Добавил:
Andrey
Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз:
Предмет:
Файл:ARM PrimeCell synchronous static memory controller technical reference manual.pdf
Источник:
X
- •ARM PrimeCell
- •Contents
- •List of Tables
- •List of Figures
- •Preface
- •About this document
- •Intended audience
- •Using this manual
- •Timing diagram conventions
- •Further reading
- •ARM publications
- •Feedback
- •Feedback on the ARM PrimeCell SSMC
- •Feedback on this document
- •Introduction
- •1.1 About the ARM PrimeCell SSMC (PL093)
- •1.1.1 Features of the PrimeCell SSMC
- •1.1.2 Programmable parameters
- •1.2 Supported memory devices
- •1.2.1 Asynchronous memory devices
- •1.2.2 Synchronous memory devices
- •Functional Overview
- •2.1 ARM PrimeCell SSMC overview
- •2.1.1 SSMC core
- •AMBA AHB interface
- •Transfer control
- •External bus interface
- •Pad interface
- •2.2 PrimeCell SSMC operation
- •2.2.1 Clock frequency selection
- •2.2.2 Memory bank select
- •2.2.3 Access sequencing and memory width
- •2.2.4 Wait state generation
- •2.2.5 Write protection
- •2.2.6 Asynchronous static memory read control
- •Output enable programmable delay
- •Asynchronous memory device accesses
- •Asynchronous burst and page mode devices
- •2.2.7 Synchronous static memory read control
- •2.2.8 Asynchronous static memory write control
- •Write enable programmable delay
- •SRAM
- •Flash memory
- •2.2.9 Synchronous static memory write control
- •2.2.10 Bus turnaround
- •2.2.11 Synchronous memory devices bus turnaround
- •2.2.12 Asynchronous external wait control
- •SMWAIT assertion timing
- •SMWAIT deassertion timing
- •SMWAIT timing diagrams
- •2.2.13 Synchronous external wait control
- •2.3.1 Byte lane control
- •Accesses to memory banks constructed from 8-bit or non byte-partitioned memory devices
- •Accesses to memory banks constructed from 16 or 32-bit memory devices
- •Elimination of floating bytes on the external interface
- •Byte lane control and data bus steering for little and big-endian configurations
- •2.3.2 Clock feedback in SSMC
- •Example of 8-bit memory device interconnection
- •Example of 16-bit memory device interconnection
- •Example of 32-bit memory device interconnection
- •2.3.3 Example of system with single output clock
- •2.4 Slave interface connection to the AHB
- •2.5 Memory shadowing
- •2.5.1 Booting from ROM after reset
- •2.5.2 External bank SMCS7 size configuration
- •2.6 Test interface controller
- •2.7 Using the SSMC with an EBI
- •Programmer’s Model
- •3.1 About the programmer’s model
- •3.2 PrimeCell SSMC registers
- •SMBCRx example configurations
- •3.2.9 SSMC status register, SSMCSR
- •3.2.10 SSMC control register, SSMCCR
- •SSMCPeriphID0 register
- •SSMCPeriphID1 register
- •SSMCPeriphID2 register
- •SSMCPeriphID3 register
- •SSMCPCellID0 register
- •SSMCPCellID1 register
- •SSMCPCellID2 register
- •SSMCPCellID3 register
- •Programmer’s Model for Test
- •4.1 Scan testing
- •4.2 Test registers
- •4.2.1 SSMC test control register, SSMCITCR
- •4.2.2 SSMC test input register, SSMCITIP
- •4.2.3 SSMC test output register, SSMCITOP
- •Signal Descriptions
- •A.1 AMBA AHB interface signals
- •A.2 AMBA AHB slave interface signals
- •A.3 AMBA AHB master interface signals
- •A.4 Non-AMBA signals
- •A.5 Input/output pad signals
- •Index
Chapter 1
Introduction
This chapter introduces the ARM PrimeCell Synchronous Static Memory Controller (PL093) and contains the following sections:
•About the ARM PrimeCell SSMC (PL093) on page 1-2
•Supported memory devices on page 1-7.
ARM DDI 0236A |
Copyright © 2001. All rights reserved. |
1-1 |
Соседние файлы в предмете Электротехника