Configuring RGMP on the Switch

RGMP is disabled by default. Use the following command to enable RGMP globally:

Coriolis> (enable) set rgmp enable

RGMP enabled.

Disabling RGMP on the Switch

To disable RGMP, use the following command:

Coriolis> (enable) set rgmp disable

RGMP disabled.

Configuring RGMP on the Router

RGMP must be enabled on each interface that has the appropriate topology. Use this command:

Router(config)# vlan−interface 3

Router(config−if)# ip rgmp

Disabling RGMP on the Router

To disable RGMP, use the following command:

Router(config)# vlan−interface 3

Router(config−if)# no ip rgmp

Note Here are some related commands that you can try on the router: debug ip rgmp [group_name | group_address]

show ip rgmp interface [interface_unit_name] show ip rgmp groups [group_name | group_address]

Displaying RGMP Groups

To display all the multicast groups that were joined by RGMP−capable routers, use the following command:

Coriolis> (enable) show rgmp group

VlanDest MAC/Route DesRGMP Joined Router Ports

————————————————————————————————————————————————

201−00−5e−46−85−111/1,2/14

101−00−5e−14−11−285/1 Total Number of Entries = 2 ‘*’ − Configured

155