Refer to the back of this manual for Factory Service and Technical Support contact information

9.2.3Direct Connection Properties

Right-click on the DIRECT CONNECTION icon to verify the properties of the new connection as follows:

Figure 107–Direct Connection Properties

General Tab

Select a device COMMUNICATIONS CABLE BETWEEN TWO COMPUTERS… as shown above.

Options Tab

Uncheck PROMPT FOR NAME…

Security Tab

Check TYPICAL (RECOMMENDED SETTINGS) and select ALLOW UNSECURED PASSWORD.

Networking Tab

Select PPP type. Ensure component TCP/IP is checked and uncheck all others.

Sharing Tab

No changes are required.

9.2.3.1Modem Configuration

Under the General tab of the Direct Connection properties click on the CONFIGURE button to open the Modem Configuration window and set the COM port speed to match with the server’s baud rate; typically 57600 bps as below:

Select Configure

to set the parameters for Modem Configuration.

Set the COM port speed to match the server, typically 57600 bps.

Uncheck all

Select OK (a second time) to close

Select OK to close window the Direct Connections Properties window.

Figure 108–Modem Configuration