- •General
- •Multmeter
- •1.2 Measuring signals with the multimeter
- •1. Sine-wave signal (alternating voltage)
- •Description of components
- •Engine speed and vehicle speed sensors
- •Temperature sensors
- •2.3 Fluid-level sensors
- •2.4 Pressure sensors
- •2.5 Proximity sensors
- •Inductive proximity sensors
- •Inspection and adjustment
- •Checking electrical systems
- •4. Removal and installation
- •Removing and installing contacts from connectors
- •Installing contact units on electrical wires
- •4.4 Removal and installation of contact units of connectors with single contact lock
- •Removal and installation of contact units of connectors with additional contact lock
4.4 Removal and installation of contact units of connectors with single contact lock
Contact units with a single contact lock are removed using the special ejector tool from contact kit A or B.
Correctly position the wires with their contact units.
Removal and installation of contact units of connectors with additional contact lock
Some connectors have an additional contact lock. Such a connector is in halves. The upper half (wire entry side) together with the lower half constitutes the additional contact lock.
In order to unlock the additional contact lock, slightly push the upper half of the connector in the direction shown by the arrow (on the connector housing). Now you can correctly position the wires with their contact units.
Contact units with an additional contact lock are removed using the special ejector tool from contact kit A or B.
Correctly position the wires with their contact units. Once the contacts have been fitted, push back the connector until it locks.