8045

30

at the ends of the truss. This means that the trusses actually span the distance between their two end bearing points.

Although there may be walls under the trusses, they are "partition" (non-load bearing) walls. The advantages of using trusses are cost and speed and ease of installation.

Trusses can be constructed to accommodate almost any roof configuration, but in a practical sense, the simpler the roof, the more attractive trusses are to use. They are ideal for a gable roof.

Stick Built Roof

The alternative to using trusses in framing a roof is to "stick build" the roof. It means that all of the roof members are cut and installed on the site.

The photo (right) shows you some of the members involved in a stick built roof. One advantage is the additional storage space you'll have in the attic.

A disadvantage may be a more complicated load carrying system throughout the house.

Pitched roof

A pitched roof is a roof for which one or more roof surfaces is pitched more than 10 degrees, and alternately a roof with two slopes that meet at a central ridge.

The pitched roof is the most common type of roof construction used in new dwellings today. The primary function of a pitched roof is to shed water from a dwelling in poor weather conditions.

Most pitched roofs are covered with either slate, synthetic slate, clay tiles or concrete tiles. They are usually laid upon a framework of timber rafters across which are fixed timber battens.

FLAT ROOF

A flat roof is a type of covering for a building. In contrast to the more sloped form of roof, a flat roof is horizontal or nearly horizontal. Materials that cover flat roofs should allow the water to run off freely from a very slight inclination. Traditionally flat roofs would use a tar and gravel based surface which is sufficient to prevent penetration. However, these surfaces tend to fail in colder climates, where ice dams and the like could block the flow of water.

7. Read the text once again and answer the following questions:

1.What are the structural elements of the house?

2.What is the footing?

3.What is the house foundation?

4.What types of foundations can you name?

5.What types are the walls divided into?

6.What is the ceiling formed by?

7.What is a stick built roof?

31

Vocabulary Focus

8. Match the words from two columns to create a phrase and make sentences to use them in your own text entitled “The house structure, its footing and the foundation”. Share your ideas with the partner:

9. Match the words from two columns to create a phrase and make sentences to use them in your own text entitled “The floor system of the house”. Share your ideas with the partner:

10. Match the words from two columns to create a phrase and make sentences to use them in your own text entitled “The walls and the ceiling”. Share your ideas with the partner:

11. Match the words from two columns to create a phrase and make sentences to use them in your own text entitled “The roof structure”. Share your ideas with the partner:

Reflection (Размышление)

Writing, Listening & Speaking

12. Individual work. Create a text about the house structure

1.Discuss the following points: a) subject;

b) a role;

c) audience;

d) a form of presenting information; e) details concerning a plotline;

f) details concerning your projecting into a chosen character.

2.Individual work. Create a text.

Help each other to improve your texts

13.Present your text to the class.

14.Write a reflection on the text «The house structure” (See appendix 3.)

33

Unit 5

BUILDING MATERIALS I. Warming up (Разминка)

1. Pair work. Read the three building material quotes and discuss the following: Which of the three quotes attracts your professional attention? Why? What is the importance of building materials in building construction in your professional opinion?

a.When we build let us think that we build forever. John Ruskin.

b.“An architect must begin at the beginning… Architects must exercise well trained imagination to see in each material, either natural or compounded plastics, their own inherent style. All materials may be beautiful, their beauty much or entirely depend upon how well they are used by the architect.” – F.L. Wright.

c.“Each material has its own message, and to the creative artists, its own song…. Every new material means a new form, a new use if it is used according to its nature.”

– F.L. Wright.

Useful terms and phrases

2. Read the following terms and phrases, mind their pronunciation:

Vocabulary Focus

3. Match the words and phrases to their translation: a)

4. Group work. Make assumptions about the content of the text. Answer the following questions and report your ideas to the class.

1.What types of building materials do you know?

2.Can you describe these materials?

3.What are their characteristic properties?

Writing

5. Individual work. Fill in the first column of the “logbook” (бортовой журнал):

III. Realization (Осмысление)

Reading

6. Read the following terms and phrases, mind their pronunciation:

7. Read the text and fill in the second column of the “logbook”:

Contemporary building materials

Any material which is used in construction of residential or commercial buildings is called a building material. The choice of building material depends on the size and nature of the building, its design, intended purposes, availability of resources and location. Let’s read about some of the most commonly used building materials all over the world.

When it comes to modern building materials, the type of materials and the design of buildings are significantly determined by society’s way of life. Since modern society is largely stable, the buildings and other structures are also permanent. Hence, there is a greater need for durable building materials.

Some examples of basic building materials used in constructing modern buildings include steel bars, concrete and wood. These are structural materials that comprise the foundation, floors, walls and ceilings of many modern buildings. Aside from purely structural purposes, these materials are also sometimes used for aesthetic purposes. Wooden materials, for instance, are used as decorative wall panels, ceilings and floor boards. Some hardwood materials are also used in making storage facilities, furniture, ornate doors and ornate window trims.

In terms of purpose, various types of building materials can be classified as structural materials, decorative or finishing materials, functional materials and protective materials.

Structural materials are fundamental and they provide the general shape and appearance of a building. The structural materials serve as the protective barriers against the natural forces, such as rain, snow, sun’s heat and wind. All other types of building materials are attached, embedded or supported by the structural materials. The decorative or finishing materials include natural stones (such as marble or granite for flooring), ceramics and wooden panels. These materials are later installed when the structure of a building is already erected.

On the other hand, the functional or utility building materials are usually hidden or embedded within the structural materials. Some utility building materials include the components of the plumbing system, the components of the electrical system and the components of the ventilation system.

37

Construction materials

The construction materials for each type of structure will vary, depending on the characteristics of the site and the type of design. However, general guidelines show that houses require stronger, more durable construction materials.

Materials must provide a good surface for waterproofing and insulation to withstand the pressure and moisture of the surrounding ground. When soil is wet or frozen, the pressure on the walls and floors increases. Pressure also increases with depth, so materials such as concrete and reinforced masonry, wood, and steel are all suitable.

Concrete

Concrete is the most common choice for constructing different types of buildings. Not only is it strong, it is also durable and fire resistant. Several forms of concrete are used in earth-sheltered constructions. Lightly reinforced concrete, which is poured and reinforced at the site, is used for noncritical structural elements such as concrete foundations, floor slabs, and exterior walls with less than 6 feet (1.83 meters) of earth cover. Precast reinforced concrete can resist loads at any reasonable depth and can be used for floors, walls, and roofs. Concrete absorbs and stores heat, helping to prevent temperature swings that can damage some building material.

Precast concrete components are manufactured at a plant or on-site location before they are used, thereby decreasing construction time and cost in comparison to cast-in-place forms. The uses and advantages of precast and cast-in-place concrete are similar, except that precast concrete works are best in simple or repeatable shapes. Special care must be taken to make the joints between sections watertight.

Masonry

Masonry (i.e., brick or stone) can be used for walls that will receive vertical or lateral pressure from earth cover. It is reinforced with steel bars that are put in the core of the masonry in places of high stress, such as weight-bearing walls or walls with earth against them. Masonry generally costs less than cast-in-place concrete.

Wood

Wood can be used extensively in earth-sheltered construction for both interior and structural work including floors, roofs, and exterior walls. Wood is attractive for its color and warmth, and complements tile and masonry, as well as concrete walls, floors, and ceilings. However, using wood as a structural material requires wooden frame walls, which must withstand lateral pressure and be restricted to a burial depth of one storey. Beyond this depth, the rapidly increasing cost of wood construction restricts most builders from using it as a structural material.

Although wood can cost less than other materials, it does not offer the strength that a material such as steel does, so it may not be the best choice for structural material in some houses. Wood must also be treated with preservatives to prevent damage from moisture. If your structure can make practical use of wood as a framing material, employing carpenters who can rapidly construct a timber frame for an earthsheltered house can decrease labor costs.

38

Steel

Steel is used for beams, bar joists, columns, and concrete reinforcement. It is particularly useful because of its high tension and compression strength. The primary disadvantage of steel is that it must be protected against corrosion if it is exposed to the elements or to groundwater. It is also expensive, so it must be used efficiently to be economical as a structural material. Steel is an iron alloy with between 0.2 and 1.7 percent carbon.

Steel is used extremely widely in all types of structures, due to its relatively low cost, high strength to weight ratio, and speed of construction.

Vocabulary Focus

8. Match the words from two columns to create a phrase and make sentences to use them in your own text entitled “My vision of structural and functional materials”. Share your ideas with the partner. (See appendix 1):

9. Match the words from two columns to create a phrase and make sentences to use them in your own text entitled “Construction materials”. Share your ideas with the partner:

10. Match the words from two columns to create a phrase and make sentences to use them in your own text entitled “Usage and characteristics of construction materials”:

Reflection (Рефлексия)

Speaking & Listening

11.Group work. Prepare a presentation about building materials according to the text and deliver it to the class. Get ready to answer questions and discuss different points of view answering questions and persisting in your opinion (See appendix 2.)

12.Group work. Reflect on your professional speech (See appendix 3.)

13.Group work. Reflect on the professional speech of other groups. Get ready to discuss different points of view answering questions and persisting in your opinion (See appendix 3.)

Writing

14. Create a quote about building materials, reflect on it, interpret and ground it (See appendix 6.)

Listening and Speaking:

15.Present your quote to the class. Get ready to discuss different points of view answering questions and persisting in your opinion (See appendix 1.)

16.Listen to the quote presentation and get ready to discuss different points of view asking questions and persisting in your opinion (See appendix 1.)

Writing

17.Write a reflection on one of the quotes from Ex. 1. (See appendix 3.)

Unit 6

DEVELOPING ONE-FAMILY MANSION HOUSE DESIGN

I. Warming up (Разминка) Listening and Speaking

1. Group work. Reflect on the following quote about the design, interpret it and share your ideas with the class. Get ready to discuss different points of view answering questions (See appendix 1.)

“The original idea makes design distinctive, function makes it work and quality adds value. “ Don Newgren.